ATORN disc brushes, grit 80, brush diameter 50 mm, silicon carbide

Application

On CNC machining centres and with the use of robots, preferably in wet sanding with cooling lubricant. Machining of flat components: precise deburring, edge rounding, fine machining after milling, surface finishing of e.g. sealing and contact surfaces.

Execution

• with longitudinal slot for clamping on face mill arbours (DIN 6357) and combination mill arbours (DIN 6358) - no additional accessories required
• Disc brushes with dense sanding bristle trim (full trim) firmly moulded into the plastic disc
• Ideally suited for the machining of aluminium

Advantage

• Post-machining directly after the cutting process - without changing the geometry of the workpiece
• Continuously released abrasive grain ensures reproducible results
• Very high dimensional stability and accuracy
• Controllable wear properties to end of tool life - no bristle breakage
• 4 x higher trim density produced than in conventional process (stamped)

Notes

Infeed with brushes of diameter 50: 0.3 mm (fine)-1.0 mm (coarse) infeed with brushes dia. 76-150: 0.8 mm (fine)-1.5 mm (coarse) Other designs available on request