Demagnetising device DM-3 250 x 165 x 75 mm

Application

For demagnetising.

Execution

• For connection to 230 V AC, 50 Hz, power-on time 100 % (50 % at full load).
• Unlike other devices, the intensity of the magnetic field is increased automatically with these devices to correspond to the size of the workpiece, i.e. no workpiece equals low power consumption and low heat development. The devices are therefore also suitable for use underneath a conveyor belt. The devices are fitted with a signal lamp, toggle switch, 3 m cable and power plug.
• Workpieces machined on permanent magnet or electromagnetic clamping plates become slightly magnetised. Demagnetising devices are used to remove this magnetisation. The workpieces are placed on one pole of the device and pushed over to the other pole. The process must be repeated a few times depending on the size and shape of the parts. The plates must not be switched off until the workpieces have been removed, as otherwise they will be magnetised again.
• The demagnetising devices are suitable for
  use in measurement rooms, workshops and
  production lines and have a demagnetisation effect on bearing rings, stamps,
  dies and other tools.

Notes

Particularly ideal for demagnetising high-alloy steels, e.g. ring bearings, stamps and moulds.

Delivery

1x demagnetising device incl. power plug and 3 m cable.