RAU work table electrically height-adjustable 1250x800x720-1120 mm Stainless steel sheet

Worktop with stainless steel sheet covering, thickness 25 mm. Worktop with stainless steel sheet covering, thickness 25 mm. Top side with a 1.5 mm thick stainless steel coating (NIROSTA®), L-shaped fold at the front edge. Stainless steel to X5CrNi18-10, material number 1.4301 in accordance with DIN EN 17441/10088-2. Splash-proof, dirt-resistant, temperature-resistant, pressure-resistant. Largely resistant to acids, oils, greases, solvents and chemicals. Covering flame-retardant (B1) in accordance with DIN 4102. panel core MDF (medium density fiberboard). System substructure, W1240 x D750 x H700-1100 mm. 2 lifting columns (50x80 mm, tested in accordance with EN 60335-1) including control unit and connection cable with plug. Skids made of profile steel tube (60x30x3 mm) including leveling feet. Complete frame made of profile steel tube (steel tube 50x25x2.5 mm) at the top under the worktop. Control element with up/down button. Electric adjustment using the 2 lifting columns with integrated linear drive. Low-noise, stepless and absolutely synchronous adjustment of the working height, even with asymmetrical loads. Adjustment travel 38 mm/s (without load). Duty cycle 10 % (6 minutes per hour or 2 minutes continuous operation at full load). Power consumption in standby mode only 0.1 W. CE Declaration of Conformity: The product complies with the essential requirements set out in the following harmonization legislation: a) Directive 2006/42/EC of the European Parliament and of the Council of 17 May 2006 on machinery, and amending Directive 95/16/EC. b) Directive 2014/30/EU of the European Parliament and of the Council of 26 February 2014 on the harmonization of the laws of the Member States relating to electromagnetic compatibility // The following harmonized standards were applied: a) DIN EN ISO 1210:2011-03 Safety of machinery - General principles for design - Risk assessment and risk reduction. b) DIN EN 1570-1 Safety requirements for lifting tables - Part 1 (except chapters 5.5.5, 5.6.11 and 5.10). Note: The system can optionally be operated independently via a battery box (accessory) so that no permanent connection to a power supply is required.