RAU work table electrically height-adjustable 2000x800x720-1120 mm EN61340

EGB worktop with melamine resin coating, thickness 28 mm (volume conductive). Top and underside with a conductive, light gray melamine resin direct coating. Melamine resin coating in accordance with DIN 68765, splash-proof and dirt-resistant, surface properties in accordance with EN 14322/EN 14323: Discharge values according to EN61340, abrasion resistance class 3A, scratch resistance N greater than 1.5, stain resistance level ? 3 (e.g. acetone, alcohol, organic solvents, white spirit), susceptibility to cracking level ? 3, resistance to cigarette burns grade 3, resistance to water vapor grade 4, safety certificate with regard to migration behavior, therefore also suitable for use in the food industry. Covering normally flammable (B2) in accordance with DIN 4102. Board core made of volume-conductive chipboard in accordance with EN 309/EN 312 (emission class E1). Light gray, antistatic ABS edge on all sides. System substructure, B1990 x D750 x H700-1100 mm. 2 lifting columns (50x80 mm, tested in accordance with EN 60335-1) including control unit and connection cable with plug. Skids made of profile steel tube (60x30x3 mm) including leveling feet. Complete frame made of profile steel tube (steel tube 50x25x2.5 mm) at the top under the worktop. Control element with up/down button. Electric adjustment using the 2 lifting columns with integrated linear drive. Low-noise, stepless and absolutely synchronous adjustment of the working height, even with asymmetrical loads. Adjustment travel 38 mm/s (without load). Duty cycle 10 % (6 minutes per hour or 2 minutes continuous operation at full load). Power consumption in standby mode only 0.1 W. CE Declaration of Conformity: The product complies with the essential requirements set out in the following harmonization legislation: a) Directive 2006/42/EC of the European Parliament and of the Council of 17 May 2006 on machinery, and amending Directive 95/16/EC. b) Directive 2014/30/EU of the European Parliament and of the Council of 26 February 2014 on the harmonization of the laws of the Member States relating to electromagnetic compatibility // The following harmonized standards were applied: a) DIN EN ISO 1210:2011-03 Safety of machinery - General principles for design - Risk assessment and risk reduction. b) DIN EN 1570-1 Safety requirements for lifting tables - Part 1 (except chapters 5.5.5, 5.6.11 and 5.10). Note: The system can optionally be operated independently via a battery box (accessory) so that no permanent connection to a power supply is required.